Flyin' Miata Butterfly Brace and Wideband O2 Sensor

My Megasquirt project is about to take a big step forward. One of the most physically challenging parts about this is install is welding a bung on the stock exhaust to hold the Innoviate wideband O2 sensor. Since I don't have a welder, or lift, or a garage, installing that sensor has been on the backburner.

That will soon, change however, as I'm putting my car in the shop next week to install a Flyin' Miata Butterfly Brace and Frame Rails. I was blown away when by how much improved the chassis felt after installing the roll-bar. The butterfly brace is said to be even better.

While Coop is doing the bracing, it'll be easy to pop that sensor on too. Sweet.

No comments:

Post a Comment